Warning signifying that it is necessary to follow the information in
the documentation precisely in order to ensure device safety and complete
functionality.
The manufacturer is not responsible for damage caused by improper
installation of the device, not maintaining the device in good technical
condition and operating the device contrary to its intended use.
Installation should be carried out by qualified personnel authorized to
install electrical devices and control and measuring equipment.
The installer is responsible for carrying out the installation in
accordance with this manual as well as safety and electromagnetic
compatibility standards and regulations applicable to a given type of
installation.
In case of an installation with control and measuring equipment, in
the event of a leak, medium under pressure causes a risk to
the personnel. During device installation, operation and inspection all
safety and precautionary requirements must be taken into account.
If the device malfunctions, it should be disconnected and handed over
to the manufacturer or to a body authorized by the manufacturer for
repairs.
In order to minimize probability of failure and resultant danger to personnel,
avoid installing the device under particularly unfavourable conditions when
the following dangers are present:
Danger of mechanical impacts, excessive shocks and vibrations.
Excessive temperature variations.
Vapour condensation, dust, icing.
Changes in product manufacture may precede an update to the user's paper documentation.
Up-to-date operating manuals can be found on manufacturer's website at www.aplisens.com
To Next Page
Loading...
Need help?
General
