6 02.A.003
1. INTRODUCTION
This manual concerns electromagnetic flow meters, manufactured in two versions:
A compact version designated PEM-1000ALW - with transmitter placed directly on
the measuring sensor;
A remote version designated PEM-1000NW - with transmitter connected via cable and
placed up to 50 m from measuring sensor.
The manual contains data, guidelines and recommendations concerning installing and
operating, as well as procedure in the event of a failure.
The description of device configuration can be found in the IK.PEM-1000(ENG) configuration
manual, and the Modbus communication is described in the IM.PEM-1000(ENG). They are
available on the manufacturer's website www.aplisens.com
2. SAFETY
Installation and start-up of the device, as well as any actions related to operation,
should be carried out only after carefully reading this manual.
Installation and maintenance should be carried out by qualified personnel
authorized to install electrical devices and control and measuring equipment.
Device should be used in accordance with intended use (item 6.1) and within
permissible parameters.
Protections ensuring device safety utilized by the manufacturer may be less
effective if the device is operated contrary to its intended use.
Before installing or removing the device make absolutely sure that it is
disconnected from power source.
Repairing or otherwise tampering with the electronic system of the device is not
permitted. Only the manufacturer or a body authorized by the manufacturer may
carry out damage assessment and necessary repairs.
Do not use damaged equipment. In case of malfunction, the device should be
removed from operation.
3. COMPLETENESS LIST
Along with the flow meter, the user receives:
a) Product Certificate, which also acts as a warranty card;
b) Declaration of conformity (on request);
c) Operating Manual designated "IO.PEM-1000(ENG)"
d) Calibration certificate
Items b) and c) are available on-line at www.aplisens.pl
On the manufacturer's website are also available:
Configuration Instructions for the flowmeter “IK.PEM-1000(ENG)”.
Instructions for handling flowmeters via the Modbus protocol “IM.PEM-1000(ENG)”
To Next Page
Loading...
Need help?
General
