02.A.003 7
4. TRANSPORT AND STORAGE
4.1. Transport
Flow meters should be transported in individual packages via means which provide cover.
Packages should be protected against moving and direct exposure to weather.
4.2. Storage
The flow meter should be stored in factory-provided packaging, in a covered room with
no vapors or aggressive substances, at temperature and relative humidity within permissible
conditions (see item 10.6).
5. WARRANTY
The manufacturer grants warranty on terms and conditions stated in the Product Certificate
which also acts as a warranty card.
Warranty shall be revoked if the device is used contrary to its intended use, this
operating manual is not followed, the device is operated by unqualified personnel or
the device has been tampered with.
6. DESIGN
6.1. Intended use and properties
The PEM-1000 electromagnetic flow meter is a precise device for measuring flow of
conducting liquids within pipeline installations.
The electromagnetic flow meter converter is intended to work only with the sensor
with which it was provided.
Replacing any of these elements on one's own is not permitted. Contact
the manufacturer if either the converter or the sensor requires replacing.
Flow meter sensor has no internal mechanical elements, which ensures uninterrupted flow of
measured medium through the entire section of the pipeline. Flow measurement does not
depend on:
liquid pressure,
viscosity,
density,
temperature,
electrical conductivity (above minimal value).
The flow meter can measure the flow of purified liquids, slurries, pulps and solutions of
varying chemical aggressivity. The lack of mechanical elements ensure a long service life of
the instrument even in the case of media with strong abrasive properties. The basic areas of
application are:
To Next Page
Loading...
Need help?
General
