38 02.A.003
11. INSPECTIONS. CLEANING. SPARE PARTS
11.1. Periodic inspections
Periodic inspections should be carried out in accordance with the standards valid for
the user.
Condition of the electrical connections on terminals (reliability of the connections) and
stability of display mounting shall be checked during the inspection.
11.2. Non-periodic inspections
If converter could be endangered to mechanical damages, electric overvoltages or incorrect
operation will be stated - then inspections shall be carried out.
If signal in measuring line is missing or its value is incorrect you should check condition of
cable, condition of connections on terminals etc. Check whether value of supply voltage and
load resistance is correct. If the line is in good working order you should check operation of
the flowmeter.
11.3. Cleaning/washing.
To remove dirt from external surfaces of the flowmeter they should be wiped/swept dry or, if
necessary, additional rubbed through with cloth moisten with water.
12. SCRAPPING, DISPOSAL
Worn-out or damaged devices should be disposed in accordance with the WEEE
directive (2012/19/UE) on waste electrical and electronic equipment or it should
returned to the manufacturer.
13. ADDITIONAL INFORMATION
13.1. Additional information
The manufacturer reserves the right to introduce design and process changes in the device
not decreasing its performance parameters.
14. REVISION LOG
To Next Page
Loading...
Need help?
General
