Troubleshooting Testing the Modem/ - 31
4. Click and hold the menu next to Method and select the Serial Tool
from the options presented.
5. Click on the Internal Modem setting under the Current Port
setting. After selecting the port, click the OK button. (You can
ignore the rest of the settings.)
6. Open the serial port by selecting Open Connection from the
Session menu.
7. Type “AT” into the Communications document. The modem
should respond with an OK message.
This procedure verifies that the program is connecting with the
modem and that the modem is responding. From here you can
either quit ClarisWorks, or if you wish, you can issue any AT
command to make modem settings or to check the modem settings.
To Next Page
Loading...
