APT 8520 - Page 39

© Ikonix USA
35
4.4.5 Create Test File – Step Mode
1. From the Mode menu press the number 3
key on the keypad to change the Mode to Step.
The next screen displayed will reect the Mode
as Step, along with a test le name or a “No File
Loaded” message if no test le has been loaded
in the List Mode:
2. Once the Mode has been set to Step press
any key to drop down the menu bar and press
the number 2 key on the keypad to enter the
File menu:
3. The File screen will be displayed and the
selections on the menu bar will change. If there
are no previously saved test les for Step Mode
the screen of the File menu will display the
selections to Add, Edit or Load a test le on the
menu bar. The Next selection on the menu bar
will not do anything:
4. To start adding a test le press the number 1
key on the keypad to select Add:
5. The next screen will display a eld with a
blinking cursor to enter a name for the le:
6. Use the keypad to enter a name for the test
le (23 character limit):