APT 8520 - Page 69

© Ikonix USA
65
BASE KEYWORD DESCRIPTION VALUE
:SEQuence:ANGLe[:STARt]
:SEQuence:ANGLe[:STARt]?
Set Start Angle 0 – 359°
:VOLTage:AC <value>
:VOLTage:AC?
Set Output AC Voltage 0.0 – 310.0 VAC
VOLTage:DC <value>
:VOLTage:DC?
Set Output DC Voltage 0.0 – 420.0 VDC
:FREQuency
:FREQuency?
Set Frequency 5 – 1200 Hz
:TIME[:DWELl] <value>
:TIME[:DWELl]?
Set Dwell Time 0.0 – 999.9
:TIME:UNIT <value>
:TIME:UNIT?
Set Time Unit HOUR, MINute, SECond, MS
:DELTa:VOLTage:AC
:DELTa:VOLTage:AC?
Set Rage of Change in Volts
AC
0.0 – 310.0
:VOLTage:DC <value>
:VOLTage:DC?
Set Output DC Voltage 0.0 – 420.0 VDC
:FREQuency
:FREQuency?
Set Frequency 5 – 1200 Hz
:TIME[:DWELl] <value>
:TIME[:DWELl]?
Set Dwell Time 0.0 – 999.9
:TIME:UNIT <value>
:TIME:UNIT?
Set Time Unit HOUR, MINute, SECond, MS
:DELTa:VOLTage:AC
:DELTa:VOLTage:AC?
Set Rage of Change in Volts
AC
0.0 – 310.0
:DELTa:VOLTage:DC
:DELTa:VOLTage:DC?
Set Time Unit HOUR, MINute, SECond, MS
:DELTa:FREQuency
:DELTa:FREQuency?
Set Rage of Change of
Frequency
0.0 – 1200
BASE KEYWORD DESCRIPTION VALUE
PULSe :FILE:ADD <file_name> Add File
0-9, A – Z, Limit 23 characters
for filename.
:FILE:EDIT|OPEN <file_name>
:EDIT|OPEN?
Edit or Open File
FILE:LOAD <file_name>
:LOAD?
Load a File
:FILE:COPY <file_source>,<file_destination> Copy File
:FILE:DELete <file_name> Delete File
D) Pulse Mode Commands and Companion Queries
These commands are used to modify test parameters for the Pulse mode on the instrument. The operating
mode of the unit should be put in Pulse mode for the commands below to work successfully. These
commands require a parameter value to be included with the command. The companion query command
will read the parameter using the same value that is used for setting the parameter.