© Ikonix USA
66
BASE KEYWORD DESCRIPTION VALUE
:FILE:TOTal? Query File Total
:FILE:INDex <value>
:FILE:INDex?
Edit or Open File
:FILE:INDex? Set File Index
:FILE:NAME? Query File Name
:COUNt
:COUNt?
Count 0 – 50000, 0 = OFF
:TRIGger <value>
:TRIGger?
Set Trigger Mode AUTo, MANual
:RANGe <value>
:RANGe?
Set Voltage Range AUTo, HIGH
:ANGLe[:STARt]
:ANGLe[:STARt]?
Set Start Angle 0 – 359°
:VOLTage:AC <value>
:VOLTage:AC?
Set Output AC Voltage 0.0 – 310.0 VAC
:VOLTage:DC <value>
:VOLTage:DC?
Set Output DC Voltage 0.0 – 420.0 VDC
:FREQuency
:FREQuency?
Set Frequency 5 – 1200 Hz
:TRANsient:AC
:TRANsient:AC?
Set Transient AC Voltage 0.0 - 310.0 VAC
:TRANsient:DC
:TRANsient:DC
Set Transient DC Voltage 0.0 – 420.0 VDC
:DUTY
:DUTY?
Set Duty Value 0 – 100 %
:PERiod Count 0 – 50000, 0 = OFF
Meter Selection Commands and Companion Queries
These commands are used to select the displayed meter on the front LCD display. The secondary meter
will be set to the selected meter by the command below. These commands require a parameter value to
be included with the command. The companion query command will read the parameter using the same
value that is used for setting the parameter.
7.4.4 Meter Subsystem
BASE KEYWORD DESCRIPTION VALUE
METer <value> METer? Select Meter
FREQuency, CURRent,
POWer, PFACtor, APEAK,
REACtive, CREStfactor,
APParent, VAC, VDC, AAC,
ADC
To Next Page
Loading...
