9
10
Bum-back time,
Current and wire
feed speed
adjustment knob
“ ” for Bum-back time adjustment.
Welding current adjustment in MIG
“synergic” mode
Wire feed speed adjustment in MIG
“separated” mode
Welding current adjustment in MMA mode
Welding current adjustment in TIG mode
11
Inductance
adjustment knob
Adjust soft or hard arc characteristics in
MIG all mode
* Parameter group
“ ”, function of parameter group storage and usage, is in support of ten parameter group
storage“0~9” with one group covering all adjustable parameters on the machine panel, including welding
mode and the related conditions and settings. Prior to any other parameters, the parameter group will
automatically save the adjusted parameters(save after keeping the same parameters for 20S).The
parameter group keeps the last used parameters when the machine is turned on again.No designated
button for storage and no manual operation for parameter storage and usage.It is easy to use parameter
group. Press the parameter switch button , turn on the parameter group “ ” LED, and switch
parameter groups by encoder “ ” . Select the parameter group and work with the related parameters,
and the group will automatically save the adjusted parameters.
* MIG welding mode “Synergic” and “separated”
There are two MIG/MAG welding mode, “synergic” and “separated”, for welding specification
adjustment:
Synergic: Current and voltage settings vary with different welding wire, wire diameter and gas; and
also at the same welding current, wire feed speed and synergic voltage may differ; the welder will
auto-match preset current and welding voltage, and users can adjust the inductance to the standard
position according to the process requirements.
In synergic mode, the welder panel will display preset current on the right LED and preset voltage on
the left LED. The synergic parameter database will auto-match the voltage based on the preset current,
with adjustment range of synergic voltage ±3.0V.
This MIG mode is suitable for unskilled welders
Separated: No relation between wire feed speed and voltage adjustment, and users need to set
values separately.
This MIG model is suitable for skilled welders
https://www.arccaptain.com/
To Next Page
