38
15. Turn the Power Switch OFF.
16. To prevent accidents, after use:
• Allow Welder to cool down.
• Unplug Welder’s power cord from outlet.
• Remove Ground Clamp from workpiece or table.
• Disconnect TIG Torch and Ground Cables.
• Close gas cylinder’s valve securely, remove regulator and replace cap.
• Disconnect Gas Hose from Welder.
• Store and secure gas cylinder.
• Clean, then store Welder and its accessories indoors out of children’s reach.
8.6 Lift TIG Welding parameters table
Following table is suitable for stainless steel welding. For other materials, consult
related materials and welding process for reference.
9. Engineer Mode
! WARINING BEWARE OF ELECTRIC SHOCK!
9.1 Setting of system parameters
https://www.arccaptain.com/
To Next Page
