Argo Aurora 800 - Section 6 Oil, Filter and Lubrication Information; 6.1 Engine Oil Information; 6.1.2 Recommended Engine Oil

23
SECTION 6
OIL, FILTER AND LUBRICATION INFORMATION
6.1 ENGINE OIL INFORMATION
Detailed information on standard workshop and safety
procedures and general installation practices is not
included here. ARGO assumes no responsibility or li-
ability for PERSONAL INJURY or VEHICLE DAMAGE
which results from any procedure performed, including
those procedures outlined here. Before performing any
procedure, an individual must have determined to his/
her satisfaction that personal injury or vehicle damage
will not result from the procedure, working environment
or tools selected.
6.1.1 Checking the Engine Oil Level
Check the engine oil level each day before operating the
engine.
To check the oil during an operating period, shut the engine
o,letitcooldownandallowtheoiltimetodrainintothe
sump before checking the oil level. Position the vehicle so
the engine is level.
Kohler engines (Figure 6-2) and Briggs EFI engines (Figure
6-3)areequippedwithadipstickandaseparateoilllertube.
To check the oil level, clean the area around the dipstick be-
fore removing. Remove the dipstick and wipe it with a clean
cloth. Re-insert the dipstick and push it all the way into the
tube. Remove the dipstick and check the oil level. The oil
level should be between the ADD and FULL marks. If the
level has dropped, add oil to bring the level up to the FULL
mark. DO NOT OVERFILL.
Do not run the engine if the oil level is above the FULL
mark or below the ADD mark. Premature engine dam-
age or total engine failure can occur when the oil level
is not properly maintained.
Figure 6-2. Kohler Aegis engine.
Figure 6-3. Briggs EFI Engine.
A - Engine ID B - Spark Plug C - Air Cleaner
D - Dipstick E - Oil Fill F - Oil Filter
G - Oil Drain Plug
6.1.2 Recommended Engine Oil
Use a high quality detergent oil of API (American Petroleum
Institute) service class as listed in chart. Choose the correct
viscosity of oil for seasonal driving conditions. Using the
proper type and weight of oil in the crankcase is extremely im-
portant. Argo Brand 5W40 synthetic oil is also an approved
engine oil for your Aurora (Part No. 130-103). Check oil
daily and change oil regularly. Failure to use the correct oil,
or using dirty oil, causes premature engine wear and failure.
OilcapacityKohler(withlter):1.9L(2.0qts.)