Argo Aurora 800 - Output Shaft Coupler Lubrication; Inner Axle Bearing Lubrication

28
6.4.7 Output Shaft Coupler Lubrication
ADM
Output shaft spline couplers are equipped with a grease
tting(Figure6-11)toallowlubricationtothesplineofthe
shaft and coupling connector. Lubricate every 25 hours with
a lithium based, NLGI #2 or 3 mineral oil based grease, (such
as Shell Alvania #3 or ARGO Brand Multi-Purpose Grease
PartNo.130-105).Wipeoexcess.
Figure 6-11. Output shaft grease tting.
6.4.8 Inner Axle Bearing Lubrication
Theinneraxleangesare equippedwith agrease nipple
(Figure 6-12). Lubricate the bearings with a small amount of
a lithium based, NLGI #2 or 3 mineral oil based grease, (such
as Shell Alvania #3 or ARGO Brand Multi-Purpose Grease
Part No. 130-105). Apply every 50 hours or before the vehicle
is taken out of service for any extended period. Dirt, dust and
exposure to water will accelerate this servicing to less than
50 hour intervals. Only a small amount of grease is required.
Figure 6-12. Inner axle ange grease nipple.
SECTION 6
OIL, FILTER AND LUBRICATION INFORMATION