Argo Aurora 800 - 7.5 Maintenance Schedule

46
AFTER INITIAL
The intervals shown on the schedule are based on average operating conditions. Vehicles which are subjected to
severe use and wet or dusty conditions will require more frequent servicing. Use only Argo replacement parts to
ensure safe operation of the vehicle and to comply with the warranty coverage.
We strongly recommend that an Argo Dealer perform a complete check-over of your vehicle after the initial
20 hours of operation, then once each year. This will reduce maintenance costs over the life of your vehicle.
X
X
X
X
X
X
X
X
X
X X
X
X X
X
(Kohler High Pressure Every 1000Hrs).
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X X
X
BEFORE
EACH
USE
EVERY
Check Coolant Level (L/C Models)
Check Fan Belt Tension (L/C Models)
Check Fuel Level
CheckTireInation
Check Finger Throttle Operation
Check Handlebar Travel
Check Engine Intake/Exhaust For Obstructions
Change That The Drain Plugs Are In Place
Check Engine Oil Level
Change Engine Oil And Filter
Check Transmission Oil Level
Change Transmission Oil
Check Clean/Replace Air Filter
Replace Fuel Filter
Check Replace Regular Fuel Filter
Service Driver And Driven Clutch
Lubricate Drive Chains
Remove, Clean & Lube Drive Chains
Lubricate Outer Axle Bearings
Lubricate Inner Axle Bearings
Lubricate Output Shafts
Lubricate Idler Shaft Bearings
Clean Battery And Terminal Connections
Clean Battery
Clean, Adjust/Replace Spark Plugs
Check Drive Belt
Check Nylon Sliders - Driven Clutch
Check Slider Blocks - Chain Take-Up System
Inspect Brake Pads
Inspect/Adjust Emergency/Parking Brake
Check Hydraulic Brake Fluid Level/Condition
Check Fuel Tank Connection/Lines
Inspect Wiring Harness
Tighten Bearing Extension/Axle Flange Bolts
Clean Out Spark Arrestor
SECTION 7
MAINTENANCE INFORMATION
2h 8h 20h 10h
25h 50h 100h 250h
7.5 MAINTENANCE SCHEDULE