62
SECTION 11
ACCESSORY INFORMATION
• Do not park on hills. Avoid side hill operation, and going
oversuddendrop-osgreaterthan12".
• Do not step on or place loads on the edge of the body
over the trailer wheels. This area of the trailer body is
intended only as a mud guard.
• Do not "train" multiple trailers together.
Follow the instructions listed in Section 6.4.5 of this manual
to service the axle bearings. Do not allow water and debris to
accumulate in the bottom of trailer body to avoid premature
bearing failure.
11.19 HEATER ACCESSORY - L/C Models Only
The heater kit includes a conventional automotive style hot
coolant heater core with 2 speed fan to circulate the warm air
through the ducts to the right side of the driver’s compartment
and the windshield. In some operating conditions, ie. high
humidity or full passenger load, defrosting the windshield and
sidepanelwindowsmaynotbeeective.
In extremely cold weather and operating at low load, the heater
may perform like a second radiator and keep the engine from
reaching proper operating temperature. Under these condi-
tions, a piece of cardboard or similar material should be used
to partially cover the engine radiator.
11.20 ROLL OVER PROTECTIVE STRUCTURES
(Vehicles manufactured to accommodate ROPS only)
The optional Roll Over Protective Structure also referred to
as a ROPS, provides additional protection for the occupants
in case the vehicle overturns, provided all occupants wear
seat belts.
However, the ROPS also introduces additional hazards that
havetobecarefullyweighedagainstthesafetybenetsof
these devices:
• If your vehicle is equipped with a ROPS, always remem-
ber that your vehicle is now more top heavy. This reduces
the vehicle's stability both on land and in the water.
Therefore, always wear your seat belt when driving on
land, but never when driving in the water. The increased
instability and weight may mean that you will no longer
be able to manoeuvre some slopes with either a ROPS
installed. Follow all weight restrictions and, as always,
drive slowly and carefully.
• Be particularly careful when driving under trees, as low-
hanging branches can upset your vehicle.
• Never place or carry anything on top of the ROPS.
The Roll Over Protective Structure (ROPS) provides roll over
protection and lap belts for the driver and front seat passenger
or for driver and front seat passenger and two passengers with
the optional rear bench seat.
The ROPS design provides reasonable protection from injury
in the event of a rollover. DO NOT rely on it to protect the
occupants from irresponsible driving.
The ROPS has been designed to meet the requirements of
the Occupational Health and Safety Act - Regulation 856
‘Roll-Over Protection Structures’ for the Province of Ontario,
Canada.
Seat belts must be properly adjusted and worn by all oc-
cupants at all times EXCEPT when operating in water.
Never carry more people in the vehicle than there are
seat belts for.
Articles must not be placed on top of the ROPS.
Use caution when travelling on uneven ground; the
ROPS reduces vehicle stability.
No part of the ROPS shall be drilled, welded or altered
in any way without the manufacturer’s authorization.
Do not exceed maximum gross vehicle weight.
Use caution when travelling tree-lined trails. Branches
could be knocked down, causing injury to the vehicle
occupants.
FAILURE TO COMPLY WITH THE ABOVE COULD
RESULT IN PERSONAL INJURY OR DEATH.
DO NOT use the ROPS as an attachment point for towing
or winching your Argo.
Check fastener tightness annually. Inspect for and re-
place any damaged or worn parts of the ROPS and the
seat belts.
11.21 BRUSHGUARD ACCESSORY
The Brushguard Kit protects the winch and headlights from
damage by the brush encountered along the trail. It features
an integrated tow hook. Installation of mounting kit or power
winch is required.
To Next Page
Loading...
