Argo Aurora 800 - 6.3 Filter Information

25
Figure 6-8. Air Cleaner Element and Inner Element.
Forinstructionsto remove,clean andreplace theairlter
components, refer to the air cleaner section of the engine
Owner’s Manual.
6.3.2 Fuel Filter (Kohler)
AURORAEFImodelshave1fuellter,locatedintherear
compartment at the fuel tank (Part No. 24 050 03). Figure
6-9.
Figure 6-9. Aurora EFI fuel lter location.
Fuel under high pressure.
ReplacetheKohlerhighpressurefuellterafterevery1000
hoursofoperationoronceayear.Toreplacethelter,loosen
the gear clamps with a standard screw driver and pull the rub-
berfuellinesoofthelter.Installthenewlterwiththe
owarrowpointingtowardtheengine.Tightentheclamps
securely. Start the engine and check for fuel leaks.
6.2.3 Relling the Transmission
ADM
Installthedrainplug.Removethell/ventpluglocatedon
the top of the transmission. Fill the transmission with 80W90
Gear Lube or ARGO brand 75W90 Synthetic lube (Part No.
130-104). Fill the transmission until the sight glass is half
full. For Oil capacity see Oil Capacity Chart (Figure 6-5).
Transmission Oil Capacity
Admiral (34-200) 1.2 L
1.1 LClassic (34-100)
Figure 6-5. Transmission Oil Capacity
6.3 FILTER INFORMATION
6.3.1 Air Filter (Briggs)
Briggs EFI engines are equipped with a foam precleaner and
drypaperairlterelementhousedinanaircleanerassembly
attached to the throttle body. Figure 6-7
Replace or wash precleaner in warm water with detergent.
Rinse and allow to air dry. Saturate precleaner with new en-
gine oil; squeeze out excess oil. Replace the paper element.
Wash and oil the precleaner after every 25 hours of operation
or more often under extremely dusty or dirty conditions.
Checkthepaperairlterelementevery100hoursofopera-
tion or more often under extremely dusty or dirty conditions.
Figure 6-7. Air Cleaner Element and Inner Element.
Air lter (Kohler)
The Kohler Aegis engine is equipped with a heavy duty high
density paper air cleaner element surrounding a canister style
inner element. Cleaning is not recommended, each element
should be replaced when dirty. See Figure 6-8
SECTION 6
OIL, FILTER AND LUBRICATION INFORMATION