Advanced features
Getting the most from your TV
Advanced features42
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
First Time Installation
• If you want to load default settings of your set top
box, you can perform first time installation.
• Select First Time Installation by using the
/
buttons and press the OK button.
• The following message will be displayed:
• Highlight No by using the
/ buttons to cancel
installation.
• Highlight Yes by using the
/ buttons and press
OK button to start first time installation.
• After you select Yes, factory settings will be loaded.
• The Installation wizard will guide you through the
installation process. See the section, First Time
Installation (page 20) for more information on this
process.
IP Settings
You can configure your receiver’s IP settings by using
this menu screen.
• Use the YELLOW button to set static IP settings.
• Use the BLUE button to configure dynamic IP
settings.
• Use the RED button to disable IP configuration.
In order for the ethernet host to work correctly with
your internet connection it needs to have a unique IP
address. In most cases all of the parameters can be
provided by the DHCP server in their router. In this case
you should use the Dynamic option.
In the unlikely event that you do not have a DHCP
server in your router, or if you prefer to assign your
own IP address, then the Static option can be used.
You will need to enter a unique IP address along with
the default gateway and DNS server. In most domestic
networks the default gateway and DNS server will both
be the IP address of the router.Available MAC address
will be displayed on MAC address line.
Fig 49.
Fig 50.
To Next Page
Loading...
