Safety information
Important - Please read these instructions fully before
installing or operating
Safety information6
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Power Safety
Power source
• Always use the provided AC adaptor.
• Operate only from the power source specified on
the AC adaptor.
• The power adaptor may become hot during normal
operation. This is not a malfunction.
• Please make sure that the adaptor is not covered
while in operation. Leave a space of 15 cm
(minimum) around the AC adaptor.
• The rating information and safety caution of the AC
adaptor are provided on the adaptor.
WARNING: When the set-top box is not in use for a
long time, disconnect it from the power.
Power Cord
• Do not place the unit, a piece of furniture, etc., on
the power cord, or pinch the cord.
• Handle the power cord by the plug. Do not pull out
the plug by tugging the cord.
• Never touch the power cord when your hands are
wet as this could cause a short circuit or electric
shock.
• Never make a knot in the cord or tie it with other
cords.
• The power cords should be routed in such a way
that they are not likely to be stepped on.
• A damaged power cord can cause fire or give you
an electrical shock.
• Check the power cord once in a while. When you
find it damaged, ask closest service agent for help.
• Please do not place the set in a place subject to
direct sun light, excessive dust or mechanical shock
or in a location near heat sources.
• The device should be placed on a solid and safe
base.
• Do not place the apparatus on a soft surface such
as a rug that might block the ventilation holes on
the bottom.
• The selected location should not have a high
humidity. Condensation, that may arise in a kitchen
for example, may cause a malfunction or damage
the device.
• Heating or other thermal radiation under the set
also may cause malfunction or damage the device.
• The hot air, which arises during operation, should
be ventilated with sufficient air circulation. Please
do not put the device into closed areas and do not
cover it.
• Please avoid contact of the device with water or
humidity. Do not put into operation near bath,
swimming pools.
• Take care to provide good air circulation. Place the
device in a location with adequate ventilation to
prevent heat build-up in the device.
• Should any solid object or liquid fall into the cabinet,
unplug the device and have it checked by qualified
personnel before operating it any further.
• The device should not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases, shall be placed on the device.
Batteries
Batteries shall not be exposed to excessive heat, for
example sunshine or fire.
Connection to a Television Distribution
System (Cable TV etc.) from Tuner
Device connected to the protective earthing
of the building installation through the mains
connection or through other apparatus with a
connection to protective earthing-and to a television
distribution system using coaxial cable, may in some
circumstances create a fire hazard.
Connection to a cable distribution system has therefore
to be provided through a device providing electrical
isolation below a certain frequency range (galvanic
isolator, see EN 60728-11).
To Next Page
Loading...
