8 www.arkrayusa.com
The GLUCOCARD Shine Meter uses two 3.0 V lithium
batteries. Before using the meter, check the battery
compartment and insert batteries if empty.
When the
symbol appears on the display for the first
time,the batteries should be replaced as soon as possible.
The test results might not be saved if the batteries run out.
InsertingorReplacingtheBatteries
Note: Removing the meter batteries will not affect your
stored result. However, you may need to reset your meter
settings. See pages 13-17.
Step 1
Make sure the meter is turned off.
Press down and slide off the battery
compartment cover.
Step 2
Remove the used batteries one at a time.
Slip your index finger under the battery to
lift and pull out as shown. Insert two new
batteries with the + side facing up and
make sure the batteries are inserted firmly
in place.
Step 3
Place the cover on the battery
compartment. Push down until you hear
the tab click into place.
To Next Page
Loading...
Need help?
General
