Note: Document subject to change.
4.3.1 login 34
4.3.2 logout 34
4.3.3 about 35
4.3.4 general settings 36
4.3.5 manual/auto mode 37
4.3.6 pump control 38
4.3.7 alarms & warnings 40
4.3.8 trend-graph 41
4.3.9 brightness adjustment 41
4.3.10 touch screen calibration 42
4.3.11 data logging 43
4.4 web interface 44
4.4.1 connecting via ethernet 44
4.4.2 connecting via wifi 44
4.5 design envelope flow readout
tolerance 46
4.6 noise levels 46
5.0 control modes 47
5.1 constant flow 47
5.2 constant pressure 47
5.3 linear pressure 47
5.5 quadratic curve control with
minimum flow protection 47
5.6 quadratic curve control with
maximum flow protection 47
5.7 quadratic curve control with
minimum & maximum flow protection 48
5.8 parallel sensorless pump control (pspc) 48
5.8.1 embedded parallel sensorless
pump control for multiple pumps 48
5.8.2 modifying motor ramp up and down time 49
5.8.3 three different control modes
can be accessed 50
5.8.4 fallback percentage of maximum speed 50
5.8.5 standby pumps 50
5.9 2*100% capacity split units 50
5.10 alternation 50
5.11 constant pressure control 51
5.12 dual season setup 51
5.13 sensored control 51
5.13.1 adding dp sensors through lcd screen 51
5.13.2 adding dp sensors from webserver 51
5.14 bypass valve control 52
6.0 maintenance 54
6.1 general care 54
6.2 lubrication 54
6.3 mechanical seal 54
6.3.1 mechanical seal replacement instructions
for rigid split- coupled pumping units
(series 4300 & 4322) 55
6.3.2 mechanical seal replacement instructions
for close-coupled pumping units
(series 4380 & 4372) 56
6.4 system cleanliness 58
7.0 warnings and alarms 58
7.1 alarm summary for interfaces 58
7.2 warning summary for interfaces 59
8.0 fuse and wire recommendation 60
9.0 pump manager 61
10.0 connectivity kit 61
To Next Page
Loading...
