Electronic Control System (ECS) 116
Note: It is possible to load a lens table even when an LDS lens is attached. The LDA values calculated
from motor positions and lens tables take precedence over the values communicated by the lens itself.
This can be necessary, if the lens data from the lens is faulty or imprecise.
NOTICE
Please note that as soon as a LDA table is activated, the LDS contacts of the lens mount are
switched off. There is no need to switch the mount off manually when using LDA.
25.3.1 Adding Lens Tables (LDA)
1. Select MENU > Electronic Control System (ECS) > Lens Data > Lens Tables Installed > ADD.
2. Press IMPORT to import lens tables from a USB medium or DEFAULTS to select a lens table from
the internal lens tables default list.
3. Select the desired lens table from the list and press IMPORT.
The lens table is imported to the cameras Lens Tables Installed list.
4. To use the lens table, select the lens table from the Lens Tables Installed list and press SET.
Some lens tables contain different scale classes for the same model. The scale class of an
individual lens is engraved on the lens barrel. If required: select the corresponding scale class from
the list.
Lens Tables Favorites List
Frequently used lens tables can be added to a favorites list. The list shows all lenses that have been
added before, including the selected scale class.
Add Lens Tables to the Favorites List
1. Select MENU > Electronic Control System (ECS) > Lens Data > Lens Tables Installed and select
and set a lens table for use.
2. Select MENU > Electronic Control System (ECS) > Lens Table > Add to Favorites to add the lens
table to the favorites list.
Select a Lens Table from the Favorites List
1. Select MENU > Electronic Control System (ECS) > Lens Data > Lens Table Favorites.
A list with favorite lens tables is displayed.
2. Select and set a lens table from the list.
To Next Page
Loading...
