Monitoring 89
Monitor Flip Mode
Auto Flips the monitor image automatically depending on the
monitor's orientation. This is the default setting.
Normal Ignores the monitor's orientation sensor and displays the
monitor image in normal orientation.
Flipped Ignores the monitor's orientation sensor and displays the
monitor image in flipped orientation (upside down).
18.10 Color Bars
Select to activate SMPTE color bars on the SDI outputs. The color bars are a 10-bit signal according
to SMPTE RP 219-2002. Color bars will always bypass the ALF-2 look file. These are SDR color bars.
Use only on SDR displays. They will, however, work properly when the camera SDI out color space is
set to either Rec. 709 or Rec. 2020.
Note: Color bar is switched off when recording is started.
► Select MENU > Monitoring > Color Bars and set the bars on or off.
To Next Page
Loading...
