System Settings 97
21 System Settings
21.1 Language Setting
1. Select MENU > System > Language.
2. Set the language to either English or Chinese (simplified).
21.2 System Time and Date
► Select MENU > System > System Time + Date to set the system time and date.
Note: Timezone and Daylight Saving Time do not change time and date settings. They are stored
as metadata in the recorded clips.
Note: System Time and Date are reset after a camera software update.
21.3 Button and Display Settings
► Select MENU > System > Buttons + Display.
Following options are available:
Display Style
Button Brightness
Choose between day mode and night mode.
Adjust the brightness of camera and MVF buttons from 0 to 4 (0 = off)
21.4 Fan Settings
Select to set the fan mode to Low Noise for locations with ambient temperatures up to 30°C (86°F).
For locations with ambient temperatures higher than 30°C (86°F), set to Rec Low. When the fan is set
to Rec Low, it will run at a high rate when the camera is in Standby, and run at a low rate when the
camera is recording.
► Select MENU > System > Fan Mode.
Following options are available:
Rec Low Increases fan speed during standby to cool the camera. Minimizes fan
speed/noise during recording.
Note: Ideal in an environment warmer than 30 °C (86 °F).
Low Noise Minimizes fan noise during standby and recording.
Note: With data rates above 100 MB/s (due to fps/codec setting), the fan
speed automatically increases to prevent the recording media from over-
heating.
21.5 Battery Warning
You can adjust the voltage level at which a power warning is displayed for the power source connected
to the BAT connector. The level can be adjusted to match the battery type used. The default warning
value is 13.5 V.
► Select MENU > System > Power > BAT In Warning and set the warning level between 11.0 V and
34.0 V.
When the power source reaches the defined voltage level the battery display on the HOME screen
and in the status info of the viewfinder and SDI outputs start flashing.
To Next Page
Loading...
