Monitoring 84
18.6.2 Zebra
In Zebra mode, the camera overlays up to two luminance ranges with diagonal stripes. High zebra
ranges above, Mid zebra around the user defined luminance value.
Zebra Configuration
► Select MENU > Monitoring > Exposure Tools > Select EVF/Mon. Exp. Tool
and select Zebra to use Zebra as exposure tool for EVF and Monitor.
► Select MENU > Monitoring > Exposure Tools > Select SDI Exp. Tool
and select Zebra to use Zebra as exposure tool for the SDI outputs.
Zebra Setup
1. Select MENU > Monitoring > Exposure Tools > Zebra Setup.
Following settings are available:
Zebra Mode
High Zebra Level
High Zebra Color
Mid Zebra Range
Mid Zebra Color
Sets the zebra mode to High, Mid, or both.
Sets the exposure level (in %) above which high zebra is active.
Sets high zebra pattern color.
Sets the active range (in %) around a mid zebra level.
Sets the mid zebra pattern color.
2. Adjust the Zebra settings to your preference.
Note: Zebra is not available on image paths with processing set to Log C. Please use False Color to
check the image exposure on image paths with processing set to Log C.
18.7 Focus Tools
18.7.1 Peaking
Peaking highlights in-focus image areas for better focus judgment. Peaking can be activated through
the camera menu or a user button.
Peaking Configuration
1. Select MENU > Monitoring > EVF/Monitor > EVF/Monitor Processing > Peaking
to configure Peaking for EVF and Monitor.
2. Select MENU > Monitoring > SDI > SDI Processing > Peaking
to configure Peaking for the SDI outputs.
3. The following options are available:
Peaking Activates Peaking for the corresponding output.
Peaking Mode Select between Color and Aperture. Select color peaking to overlay in-
focus areas with a color, and select aperture peaking to enhance object
edges only.
Peaking Level Sets a peaking strength in range from 1 (minimum) to 20 (maximum).
To Next Page
Loading...
