Appendix 131
Following Art. 3.1 b,
2014/30/EU:
EN 301 489-1 V2.1.1
EN 301 489-17 V3.1.1
EN 55032:2015
EN 55035:2017
Art. 3.2 EN 300 328 V2.1.1
Essential Requirements regarding No 2:
EN 50581:2012
To evaluate the respective information, we used:
http://ec.europa.eu/growth/single-market/european-standards/harmonised-standards/index_en.htm
Year of affixed CE-marking: 2019
APPENDIX I - List of Primes
Item Model Name
1 ARRI Signature Primes with Lens Data System 2 with focal lenght 18-280 mm
2 PL-to-LPL Adapter + ARRI Lenses with Lens Data System 1
APPENDIX II - List of Antennas
Item Manufacturer Model Name Gain
(dBi)
Radiation
Pattern
Type Connector
For ECS White Radio RF Module EMIP400s:
1 Nearson S131AM-2450S 2.0 Omni-directional Dipole Reverse SMA
2 Proant 333 (Ex-it 2400
Foldable)
2.0 Omni-directional Dipole Reverse SMA
3 Radial/Larsen R380.500.125 2.0 Omni-directional Dipole Reverse SMA
4 Wanshih WSS002 2.0 Omni-directional Dipole Reverse SMA
5 Taoglas GW26.0151 1.8 Omni-directional Monopole Reverse SMA
For WiFi 2.4 GHz RF Module ST60-2230C:
6 Radial R380.500.150 0.0 Omni-directional Monopole Reverse SMA
7 LAIRD LSR/001-009 2.0 Omni-directional Dipole Reverse SMA
FCC Compliance Statement
Class B Statement: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
To Next Page
