Arrow MAX1000 - Page 57

74 pages

Save Page as PDF

To Next Page

To Previous Page

MAX1000 User Guide www.arrow.com

Page | 57 July 2017

5.2.10.6 Ensure that the file is added to the Project: Assignments  Settings and select

“Timequest Timing Analyzer”. The top.sdc should have been already added by

default. If it is not, it will need to be added manually.

Main Page

Table of Contents2
About Arrow MAX1000 Board5
MAX1000 Iot / Maker Board5
Getting Help6
- Introduction to the MAX1000 Board7
Useful Links6
Figure 1 - MAX1000 Board (Top View)7
Layout and Components7
Block Diagram8
- Figure 2 - MAX1000 Block Diagram8
- Connections and Peripherals of the MAX1000 Board10
Board Status Elements10
Clock Circuitry10
Figure 3 - Position of Indication Leds10
Figure 4 - MAX1000 Clock Tree10
Peripherals Connected to the FPGA11
- Leds11
- Figure 5 - LED Connections11
- Push Buttons12
- Figure 6 - Button Debouncing12
- Figure 7 - Button Connections12
- Accelerometer13
- Figure 8 - Accelerometer Connections13
- SDRAM Memory14
- Figure 9 - SDRAM Connections14
- Flash Memory15
- Figure 10 - Flash Connections15
- User I/O16
- Arduino MKR Connectors16
- Figure 11 - User I/O Connections16
- Figure 12 - Arduino MKR Header Connections16
- PMOD Connector18
- Figure 13 - PMOD Header Connections18
- Communication and Configuration19
- Figure 14 - UART Connections19
- Figure 15 - JTAG Connections20
- Power Tree21
  - Figure 16 - Power Tree Connections21
  - Software and Driver Installation22
Installing Quartus Prime Software (Windows)22
Installing Arrow USB Programmer2 (Windows)24
MAX1000 User Guide Www.arrow.com Page | 4 July25
Installing Quartus Prime Software (Linux)26
Installing Arrow USB Programmer2 (Linux)28
- New Project with MAX100030
Creating a New Blinky Project with MAX100030
Building a Blinky Project with MAX100035
- Block Diagram35
- Components of the Design35
- Catalog IP36
- Create and Configure the PLL37
- MAX1000 User Guide Www.arrow.com Page | 2 July38
- Create and Configure the Counter41
- Create and Configure the Multiplexer44
- Adding the Components to the Schematic47
- Connecting the Components49
- Analysis and Synthesis55
- Adding Timing Constraints55
- Pinning Assignments58
- Compiling the Design61
- Reading the Compilation Report63
  - Configuring the MAX100064
Configure the FPGA in JTAG Mode64
Internal Configuration69
- Common Issues and Fixes71
- Appendix72
Revision History72
Legal Disclaimer73
MAX1000 User Guide Www.arrow.com Page | 3 July74

Related product manuals

Arrow CYC5000

70 pages

Arrow MAX1000 - Page 57

Table of Contents

Related product manuals