Arrow MAX1000 - MAX1000 User Guide Www.arrow.com Page | 2 July

74 pages

Save Page as PDF

To Next Page

To Previous Page

MAX1000 User Guide www.arrow.com

Page | 38 July 2017

5.2.4.2 Click “Next”.

5.2.4.3 Simplify the PLL, by disabling areset and locked outputs.

The setting should look like this:

Main Page

Table of Contents2
About Arrow MAX1000 Board5
MAX1000 Iot / Maker Board5
Getting Help6
- Introduction to the MAX1000 Board7
Useful Links6
Figure 1 - MAX1000 Board (Top View)7
Layout and Components7
Block Diagram8
- Figure 2 - MAX1000 Block Diagram8
- Connections and Peripherals of the MAX1000 Board10
Board Status Elements10
Clock Circuitry10
Figure 3 - Position of Indication Leds10
Figure 4 - MAX1000 Clock Tree10
Peripherals Connected to the FPGA11
- Leds11
- Figure 5 - LED Connections11
- Push Buttons12
- Figure 6 - Button Debouncing12
- Figure 7 - Button Connections12
- Accelerometer13
- Figure 8 - Accelerometer Connections13
- SDRAM Memory14
- Figure 9 - SDRAM Connections14
- Flash Memory15
- Figure 10 - Flash Connections15
- User I/O16
- Arduino MKR Connectors16
- Figure 11 - User I/O Connections16
- Figure 12 - Arduino MKR Header Connections16
- PMOD Connector18
- Figure 13 - PMOD Header Connections18
- Communication and Configuration19
- Figure 14 - UART Connections19
- Figure 15 - JTAG Connections20
- Power Tree21
  - Figure 16 - Power Tree Connections21
  - Software and Driver Installation22
Installing Quartus Prime Software (Windows)22
Installing Arrow USB Programmer2 (Windows)24
MAX1000 User Guide Www.arrow.com Page | 4 July25
Installing Quartus Prime Software (Linux)26
Installing Arrow USB Programmer2 (Linux)28
- New Project with MAX100030
Creating a New Blinky Project with MAX100030
Building a Blinky Project with MAX100035
- Block Diagram35
- Components of the Design35
- Catalog IP36
- Create and Configure the PLL37
- MAX1000 User Guide Www.arrow.com Page | 2 July38
- Create and Configure the Counter41
- Create and Configure the Multiplexer44
- Adding the Components to the Schematic47
- Connecting the Components49
- Analysis and Synthesis55
- Adding Timing Constraints55
- Pinning Assignments58
- Compiling the Design61
- Reading the Compilation Report63
  - Configuring the MAX100064
Configure the FPGA in JTAG Mode64
Internal Configuration69
- Common Issues and Fixes71
- Appendix72
Revision History72
Legal Disclaimer73
MAX1000 User Guide Www.arrow.com Page | 3 July74

Arrow MAX1000 - MAX1000 User Guide Www.arrow.com Page | 2 July

Table of Contents

Related product manuals