Artistic Licence micro-scope 3a - Using Palettes

Artistic Licence Engineering Ltd. Micro-Scope 3a user guide
55 / 73
USING
PALETTES
To display the palette, click on the
Palette button at the top of the screen.
The Palette contains 50 entries that
contain settings for every attribute of
every fixture.
These values are defined in the Fixture
Editor.
For ease of use, the palette entries are
coded by colour, but they are equally
valid for use with position and beam
attributes.
The palette can be used in both
spreadsheet and fader view of a Memory.
Simply drag the required palette entry
and drop it on the required fixture. The
cursor changes to a hand icon with a small
moving lamp icon.
The entire fixture changes to represent
the levels contained in the palette. This drag and drop function can
be further modified by combination of the Shift, Ctrl and Alt keys
as detailed in the table below.
Hold
Key
Cursor
Dropping on
Channel Type
Result
None
Moving
Lamp Icon
All
Entire fixture is set to the
level contained in the
palette.
Shift
Fader Icon
All
Only the channel that is
dropped upon will change to
the palette value.
Ctrl
Light Bulb
Intensity
All intensity channels within
the fixture change to the
levels contained within the
palette.
Arrows
Position
All intensity channels within
the fixture change to the
levels contained within the
palette.
Colour
Wheel
Colour
All intensity channels within
the fixture change to the
levels contained within the
palette.