35
Cleaning position
Beware: The cleaning position can only be
used when the backpack battery is not inserted
on the adapter plate.
Fig.13:
Caution
Risk of injury.
Guide bar can snap back.
► To provide secure stand, place the guide
bar onto the ground.
1. Pull the lever of the height adjustment for
handlebar out of the notch and flip the
guide rail to the front (do not crush the
Bowden cables).
2. Flip the device to the rear as shown in the
figure.
3. Place the guide bar on the floor.
Cleaning the device
Depending on use, clean the device thor-
oughly, especially the bottom and the blade.
Grass build-up and dirt that are stuck interfere
with the grass ejection and impair the cutting
quality. To sufficiently cool the engine, keep
the engine cover, air filter and engine clean.
For cleaning, use a hand brush. Remove stub-
born dirt with a wooden or plastic spatula.
Clean the outside housing parts with a cloth.
Do not clean the device, the battery and the
charger with water spray or high-pressure
cleaner! Do not use any aggressive cleaning
agents.
Keep the connections of the batteries and the
battery compartment clean.
General inspection
To make sure that the device can be operated
safely, check all nuts, bolts, screws etc. regu-
larly for proper condition and firm seating.
Check all electrical cables for damage.
Immediately replace damaged or worn parts,
especially covers, engine enclosure, cover of
battery compartment, battery and charger (au-
thorised service centre).
Check all parts that contain fluids for leaks and
proper condition. These can be: Gearboxes,
battery.
In case of leaks contact an authorised service
centre.
To Next Page
Loading...
