TD 92679GB
12 April 2011 Ver. D
Installation Guide
Elise3
20
Install the Port Driver on Windows 7
Note: When switching between mass storage mode and network mode, it takes about 30
seconds before the module can be accessed with the 192.5.36.229 address.
1 Connect a mini-USB type B cable between the USB port on your PC and the
management port on the module.
2 Press the Mode button twice to change the mode to mass storage.
The module will now turn up as a mass storage device on your computer. This is
indicated by slow flashing blue light
on the Mode button LED.
3 Locate the required “elise3.inf” driver and save it on your PC.
4 Press the Mode button twice again to change the mode to network access
1
.
5 Select Control Panel > Hardware and Sound.
6 Select “Device Manager” under Devices and Printers.
7 Right click “RNDIS/Ethernet gadget” and select “Update driver software”. A new
window opens.
8 Click “Browse my computer for driver software”.
9 Browse to the folder where the port driver is saved and click “Next”. A Windows
security window opens.
10 Click “Install this driver software anyway”. The installation of the port driver begins.
1. If not pressed within 10 minutes the module will automatically change to Network access (default mode).
To Next Page
Loading...
Need help?
General
