AC24/30/36 Operations Manual....
33
6.4 REMOTE COMMUNICATIONS, cont.
Remote control can be accomplished with the use of the ASEA Power Systems defined Remote
Communication Command Set, or through visual touch screen software that is described elsewhere.
Many standard serial communication programs have been tested with the RS-232C Command Set
and were found to function adequately.
Contact the factory for optional Modbus software protocol and RS-485 hardware connections.
What follows is a listing of the available commands through standard serial protocol. The
commands are given in the form that they should be sent: the colons and upper-case characters are
mandatory; the question marks (except dual query/setting commands) and lower-case letters are
optional. The commands may be sent in either lower-case or upper-case characters with a carriage
return [Enter] following each command (except for the “Immediate Commands” which execute
instantly after the two characters have been typed). Contact the factory for questions regarding the
use of commands listed herein.
To Next Page
Loading...
