September 2003
INSTALLATION INSTRUCTIONS
Page 22
5300LN Series Parts & Service Manual
1
3
2
To Remove Cylinder Handle
1. Insert key and rotate counterclockwise 45°.
2. Depress retainer with tool provided.
3. Slide lever off lock. (Also applies to inside lever
of 5321LN lock function.
)
1210 6-Pin
Interchangeable
Core Cylinder
Ya
le
To Replace or Install Cylinder
1. Remove the sleeve from inside the shank or from the old cylinder.
2. Slide cylinder into sleeve.
3. Rotate key 45° counterclockwise. Depress retainer plate, push the
handle onto the shank until fully seated. Pull on handle to ensure
proper
ly seated.
Finish Care
This lockset is designed to provide the highest standard of product quality
and performance. Care should be taken to ensure a long-lasting finish.
When cleaning is required use a soft, damp cloth. Using lacquer thinners,
caustic soaps, abrasive cleaners or po ishes could damage the coating
and result in tarnishing.
l
5300 GRADE 2
KEY-IN-LEVER
CYLINDRICAL
LOCKSET
Through Bolts (2) Req'd
81-0012-0584
#10-32 UNF-2A
2-1/2" (2" for 5328 & 5329) on 1-3/8" & 1-3/4" Doors
3" (2-1/2" f
or 5328 & 5329) on 2" & 2-1/4" Doors
Inside Rose
Support Assembly
14-5301-0002
Rose Scalp
14-5300-2024
14-5300-3024
Inside Lever Handl
e
Outside
Lockbody Assemb
ly
Attaching
Screws
81-2012-0416
(Cylinder and Sleeve must be properly
installed or the security of the lock will be
compromised.)
Note:
Connecting Bar
Ya le® Cylinder
Cylinder Sleeve
14-5305-9078
To Next Page
Loading...
