37
Calibration Due Date
It is recommended that calibration should be performed at least once a year. It is
recommended that the Calibration Due Date not bet set greater than one year from
the Calibration Date displayed.
From the Calibration Alert Setting screen, highlight the Calibration Due parameter by
using the left or right arrow keys. The left and right arrow keys will toggle the
highlighted area of the screen between the Calibration Due and Alert Date.
Using the left and right arrow keys and the numeric keypad enter the Calibration Due
Date. Press the ENTER key to finish.
Alert Date
The Alert Date is like an alarm clock that will warn you in advance of the actual
calibration due date. After a calibration is performed the Alert Date is automatically
set 11 months after the calibration date. For example, if the calibration is performed
on 12/15/2012 the Alert Date will automatically be set to 11/15/2013. Although this
date is automatically written into the Alert Date location, it may be manually
overwritten to any advanced date desired.
At the Calibration Alert setting screen, highlight the Alert Date parameter by using the
left or right arrow keys. The left and right arrow keys will toggle the highlighted area of
the screen between the Calibration Due and Alert Date.
Within the Alert Date parameter are three separate fields: month, day, and year.
Using the left and right arrow keys select the field you want to edit. Using the numeric
keypad enter the new number. Once you begin typing a new number, the parameter
will blank and the cursor will begin blinking. This indicates that the parameter is being
edited. Once a parameter is edited, it is necessary to complete the edit either by
To Next Page
Loading...
Need help?
General
