EasyManua.ls Logo

Astar PhysioGo 700C - Screen Configuration

Astar PhysioGo 700C
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Unit operation
PHG 700C / 701C User Manual Page 22 of 47
It is necessary to follow the recommendations provided below when choosing energy density:
at the beginning of treatment series and in acute conditions it is necessary to use smaller doses up
to 4 J/cm
2
it is always necessary to observe the reaction of the patient’s organism,
in chronic conditions higher doses, above 4 J/cm
2
.
In therapy it is allowed to use the following application techniques:
single point or several points within a given area (e.g. painful points or acupuncture points, wound
along the edges or within a small distance from the wound, within a knuckle);
grid method and scanning (large surfaces).
In each technique it is necessary to ensure that the radiation beam is at right angle on the tissue.
4.2 Screen configuration
Figure 4.1. Field description
Symbol Display Description
1 Status tab
Date and time
Battery
Quality level battery charging symbols
80% Percentage of charging level
Eco battery mode charging up to 80%
Mains cable connected
2 Main menu
Therapy selection menu
Program mode
Manual mode
User-defined treatment programs and sequences edition
mode
Information mode
Setup mode

Table of Contents

Related product manuals