Astar PhysioGo 700C - User Sequences

4. Unit operation
page 35 of 47 issue date 24.02.2021, release 11.1
Step Description
5.
Select the action – Edit.
6.
Correct the parameters.
7.
Press the button from main menu.
8.
Select the item number under which the program will be saved. Confirm your choice with the key
9.
Enter or edit the program name. Press the key or button
Removal of user program:
Step Description
1. Prepare the unit to work in the program mode (see section 4.5).
2.
Select the option User programs from Program modes menu. Confirm by the key
or once again
press the selected field.
3.
Select the program which will be deleted.
4.
Press the button from main menu.
5.
Select the action – Remove.
6.
Confirm by pressing or resign using
User program parameter view:
Step Description
1.
Prepare the unit to work in the program mode (see section 4.5).
2.
Select the option User programs from Program modes menu. Confirm by the key
or once again
press the selected field.
3. Select the program which parameters will be checked.
4.
Press button
5.
Press the key or button to return to the user-defined treatment program list.
4.9 User sequences
The unit is equipped with an advanced editor which allows you to create electrotherapy treatment sequences. A
single sequence may consist of up to four stages. The sequence may be created from previously saved user-
defined programs.
The user sequences are selected in the same way as preset treatment programs. In Program modes menu select
the option User sequences.
Step Description
1.
Switch on the unit.
2.
Select the tab 1 or 2 depending on needs or availability.
Select the therapy
3.
Press the field Program modes
4.
Select the option User sequences from Program modes menu. Confirm by the button or once
again press the selected field.