Asus SABERTOOTH 990FX R3.0 User Manual

ASUS SABERTOOTH 990FX R3.0
4-19
Chapter 4
4.4.6 Push Notice
This utility allows you get the detailed status of your system to your smart device. You can
also send messages to your smart device using this utility.
Before using this utility, ensure that you pair your computer with your smart device. For
pairing information, refer to section Pairing your computer and smart device.
Launching Push Notice on your computer
To launch Push Notice, click on the left of the AI Suite 3 main menu, then select Push
Notice.
Push Notice screen
Click or tap to enable or disable Push Notice
Click or tap to
apply the settings
Click or tap to
discard the settings
Tick to select the
smart device
You can also enable the Push Notice via the Push Notice shortcut on the lower-right corner
of your screen. To do this, click or tap << then click or tap
then select .
Pairing your computer and smart device
To pair your computer and smart device:
1. On your smart device, tap
Push Notice
to launch Push Notice.
2. Tap Push Scan then tap the name of your computer that you want to pair with.
To pair your computer and smart device, ensure that both are connected to the same
wireless network.

Asus SABERTOOTH 990FX R3.0 Specifications

General

Chipset	AMD 990FX/SB950
CPU Support	AMD AM3+ FX/Phenom II/Athlon II/Sempron 100 Series Processors
CPU Socket Type	AM3+
Storage	6 x SATA 6Gb/s
SATA RAID	RAID 0, 1, 5, 10
Audio	Realtek ALC1150 8-Channel High Definition Audio CODEC
LAN	Intel I211-AT, 1 x Gigabit LAN Controller(s)
Form Factor	ATX
Dimensions	12 inch x 9.6 inch ( 30.5 cm x 24.4 cm )
Memory Support	4 x DIMM, Max. 32GB, DDR3 1866/1600/1333/1066 MHz, ECC, Non-ECC, Un-buffered Memory
Expansion Slots	1 x PCIe 2.0 x1 1 x PCI
USB Ports	12 x USB 2.0 (6 at back panel, 6 at mid-board)
Power Pin	24-pin ATX Power Connector, 8-pin ATX 12V Power Connector
Multi-GPU Support	Supports NVIDIA Quad-GPU SLI and AMD Quad-GPU CrossFireX Technology