EN 10
Installation
•
Check the appliance for transport damage. Do not connect a
damaged appliance.
•
This appliance should only be connected by a registered
installer!
•
Faulty parts may only be replaced by original parts. The
manufacturer can only guarantee that original parts meet
safety requirements.
•
To avoid dangerous situations, a damaged connecting
cable should only be replaced by the manufacturer, the
manufacturer’s service organisation or suitably qualifi ed
persons.
•
The electrical connection must comply with national and
local regulations.
•
The wall plug socket and plug should always be accessible.
•
If you want to make a fi xed connection, make sure that a
omnipolar switch with a contact separation of at least 3 mm
is fi tted in the supply cable.
•
The equipment should not be connected to the network via
a multi-plug socket or extension lead, as the safe use of the
equipment can then not be guaranteed.
•
WARNING: Never open the appliance casing. The casing
may only be opened by a service technician.
•
Disconnect the appliance from the mains supply before
starting any repair work.
•
Freestanding micro wave ovens shall not be placed in a
cabinet.
•
Appliance should allow to disconnection of the appliance
from the supply after installation. The disconnection may be
achieved by having the plug accessible or by incorporating a
switch in the fi xed wiring in accordance with the wiring rules.
If the safety instructions and warnings are not followed, the
manufacturer cannot be held responsible for any resulting
damage.
If you decide to discontinue using the appliance because of
a fault, we recommend you cut o the cable after removing
the plug from the plug socket. Take the appliance to your
municipality’s waste disposal site.
SAFETY (CONTINUED)
To Next Page
Loading...
Need help?
General
