EN 21
3) Be careful when removing the plate as it is hot. First leave the door a little open to allow the hot
steam to escape. Pay attention to the steam outlets as well.
4) When you have fi nished cooking, pull the water tank out of the appliance slowly and empty the
tank.
5) Dry the cooking cavity with a dry cloth if there is any remaining water.
6) The cooling fan (10 minutes) and drain pump (10 sec) always work after a steaming process.
However, this is not a malfunction and you do not need to worry about this.
Remove the remnant water.
1
After fi nish the steam mode, empty the
water tank and place it back.
2
Turn the Mode Selector to “OFF”
position.
3
Press Temp and Back at the same
time and hold for 2 seconds. And
then press Next/Start. The oven starts
removing the remnant water and
displays 20 seconds.
4
Remove the water tank and empty any
remnant water.
USING THE STEAM MODE (CONTINUED)
To Next Page
Loading...
Need help?
General
