• If there are two one-line wall jacks, use both long line cords.
Insert one end of the clear cord into the jack labeled L1 OR
L1/L2 on the back of the telephone. Then, plug the other end
into the wall jack for Line 1. Insert one end of the black cord
into the jack on the back of the telephone labeled L2. Then,
plug the other end into the wall jack for Line 2. Make sure
the cords snap firmly into place at both ends.
3. Connect the handset to the telephone.
Plug the handset cord into the handset jack on the left side of the
telephone. Plug the other end of the handset cord into the handset,
then hang up.
continued on page 8
Table/Desk Installation
1. Attach the desk wedge.
If the desk wedge is not already attached, slide the tabs into the
holes as shown. Snap the wedge onto the base.
2. Connect the line cord(s) to the telephone and your modular
wall jack(s).
• If there is a single two-line wall jack, use only the black
(4-connector) line cord. Plug one end into the jack labeled
L1 OR L1/L2 on the back of the telephone. Plug the other
end into the wall jack. Make sure the cord snaps firmly into
place at both ends.
76
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
To Next Page
Loading...
Need help?
General
