75
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF Exposure Information (SAR)
This mobile phone meets the government’s requirements for exposure to
radio waves. This phone is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. The exposure standard
for wireless mobile phones employs a unit of measurement known as the
Specic Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests
for SAR are conducted using standard operating positions accepted by the
FCC with the phone transmitting at its highest certied power level in all tested
frequency bands.
Although the SAR is determined at the highest certied power level, the actual
SAR level of the phone while operating can be well below the maximum value.
This is because the phone is designed to operate at multiple power levels so
as to use only the power required to reach the network. In general, the closer
you are to a wireless base station, the lower the power output.
The highest SAR value for the model phone as reported to the FCC when
tested for use at the ear is 0.76 W/kg, and when worn on the body, as
described in this user guide, is 1.21 W/kg (Body-worn measurements differ
among phone models, depending upon available accessories and FCC
requirements.).
While there may be differences between the SAR levels of various phones and
at various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this model phone with
all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on le with the FCC and
can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid
after searching on FCC ID: XD6U115AA.
To Next Page
Loading...
Need help?
General
