6
Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change
to wall mounting, see Installation options on page 11 for details.
Telephone base installation
Raise the antenna.
Plug the other end of the telephone
line cord into the telephone jack on
the back of the telephone base.
Route the power
adapter cord through
this slot.
Plug the small end of
the telephone base
power adapter into the
power adapter jack
on the back of the
telephone base.
Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by
a wall switch.
Plug one end of the
telephone line cord into
a telephone jack or a DSL
filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Route the telephone line
cord through this slot.
To Next Page
Loading...
Need help?
General
