Answering system
76
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be
heard over the speaker when they are being recorded. If you
turn call screening on, you hear the incoming message. While
monitoring an incoming message, you can answer the call by
pressing
PHONE/FLASH on the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
SELECT to enter the main menu.
2. Press
CID or DIR to scroll to Answering sys,
then press MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup,
then press
MENU/SELECT.
4. Press MENU/SELECT to select Call screening.
5. Press CID or DIR to choose On or Off.
6. Press MENU/SELECT to save the setting. You hear
a confirmation tone.
NOTE: For more information on call screening, see page 84.
Voice guide
>Ans sys setup
>
Call screening
# of rings
CALL SCREENING
>On
To Next Page
Loading...
