Multiple handset use
42
Push-to-talk (PTT)
PTT call to a single device
1. There are a few ways to begin a PTT call to a
single device. When the handset is not in use:
If you have a two-handset system, press and
hold PUSH TO TALK.
If you have more than two handsets:
Press PUSH TO TALK on the handset, then
use the dialing keys to enter the destination
device number.
-OR-
Press PUSH TO TALK on the handset. Press
CID or DIR to highlight the destination
device number, then press MENU/SELECT or
PUSH TO TALK.
The handset shows Connecting to HANDSET
X...
(HANDSET represents the handset name, X represents the
destination handset number).
When the connection is made, both
your and the destination device screens display
Press and hold [PTT] to talk.
2. Press and hold PUSH TO TALK. A chirp indicates
your microphone is on. Speak towards the device.
Your voice is broadcast to the destination device.
While you are speaking, your handset shows
PTT To handset: X.
3. Release PUSH TO TALK after speaking. Both devices beep once
again and the screens show Press and hold [PTT] to talk, then
you can press and hold PUSH TO TALK to continue speaking or
the destination device can respond (see Answer a PTT call on
page 44).
4. To end the PTT call, press
OFF/CANCEL or place the handset in
the telephone base or charger. The handset shows Push to talk
Ended.
•
•
PUSH TO TALK
>HANDSET X
Connecting to
HANDSET X...
Press and hold
[PTT] to talk
PTT To
handset: X