Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least
one new message, the telephone base beeps every ten seconds. By
default, the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
SELECT to enter the main menu.
2. Press
CID or DIR to scroll to Answering sys,
then press MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup,
then press MENU/SELECT.
4. Press
CID or DIR to scroll to Msg alert tone,
then press MENU/SELECT.
5. Press CID or DIR to choose On or Off.
6. Press
MENU/SELECT to save the setting. You hear a confirmation
tone.
NOTES:
The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
To temporarily turn off the message alert tone, see page85.
•
•
Remote code
>
Msg alert tone
MSG ALERT TONE
>On
To Next Page
Loading...
Need help?
General
