Getting started
11
1. Plug the power cord and telephone line into the telephone
base. If you are using a DSL filter, plug the other end of the
telephone line into the filter. Route the telephone line cord (or
DSL filter) through the wall mount bracket hole.
2. Position the telephone base, as shown below. Insert the
extended tabs (marked B in the following illustration) of the wall
mount bracket into the slots on the back of the telephone base.
Push the telephone base down until it is securely in place.
3. Plug the telephone line cord (or DSL filter) into the wall jack.
Plug the power adapter into a power outlet not controlled by a
wall switch.
4. Align the holes on the wall mount bracket with the standard
wall plate and slide the wall mount bracket down until it locks
securely. Bundle the telephone line cord and power adapter cord
neatly with twist ties.
Installation options
Your telephone base is ready for tabletop use. If you want to mount
your telephone on a wall, follow the steps to connect the telephone
base with a standard dual-stud telephone wall mounting plate. You
may need a professional to install the mounting plate.
Tabletop to wall mount installation
1
2
4
3
To Next Page
Loading...
Need help?
General
