13
Chapter 3
Basic Operation
Port Switching
There are four methods to switch between the computers: Manual – by pressing
the port selection pushbuttons on the front panel; Mouse – by double-clicking
the scroll wheel; Hotkey – by entering key combinations on the keyboard; and
RS-232 Commnads – by entering the correct command and control.
Manual Switching
For manual port selection:
Press and release a port selection pushbutton to bring the KVM focus, plus
the USB and Audio focus, to the computer attached to its corresponding
port.
Press and hold a port selection pushbutton for more than 2 seconds to
bring the KVM focus to the computer attached to its corresponding port.
The USB and Audio focus does not change – they stay with the port that
they are already on.
Press a port selection pushbutton twice to bring the audio focus to the
computer attached to its corresponding port.
Press and hold port selection pushbutton 1 and 2 for more than 2 seconds
to start Auto Scan Mode (see page 25 for details).
Press and release either port selection pushbutton to stop Auto Scan Mode.
The KVM focus goes to the computer attached to the corresponding port
of the switch you pressed.
Mouse Switching
For mouse port selection: Double-click the scroll wheel of your USB mouse to
cycle through the ports.
Note: 1. Mouse switching is only supported by USB 3-key scroll wheel mice.
2. Mouse switching is disabled by default. See Mouse Port Switching,
page 30, to enable mouse switching.
3. Mouse switching is only supported when Mouse Emulation is
enabled.
To Next Page
Loading...
Need help?
General
