ATEN CS1922M - Upgrade Status and Completion

Chapter 4. Hotkey Operation
29
Keyboard Language
To change the keyboard language, do the following:
1. Invoke HSM (see page 26).
2. Press [F6] [nn] [Enter].
Note: nn is a two-digit number that represents the keyboard language code
(US English: 33; French: 08; Japanese: 15; German: 09).
Port Switching Keys
To disable the Port Switching Keys ([Scroll Lock] [Scroll Lock] / [Ctrl]
[Ctrl]), do the following:
1. Invoke HSM (see page 26).
2. Press [X] [Enter].
This procedure is a toggle. Repeat to revert to the original setting.
Firmware Upgrade Mode
To set the switch to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see page 26).
2. Key in: [U] [P] [G] [R] [A] [D] [E].
3. Press [Enter]. The front panel LEDs flash to indicate the upgrade has
started.
To exit Firmware Upgrade Mode, you must power off the switch.
Restore Default Settings
To reset the switch to its default hotkey settings, do the following:
1. Invoke HSM (see page 26).
2. Press [R] [Enter].
All hotkey settings return to the factory default values (See Hotkey Default
Settings, page 47).