40
DISPLAY F= AA
显示屏V显示故障码，同时复位键旁边或显示
屏F右边(触控面板型式)的LED灯会闪烁。
E01:防撞条被撞击
E02:启动失败(机器不能动作)
E03:机器断电或急停之后需按复位键E重启动
E08:编码器故障(胶膜架升降无法动作)
E09:胶膜断裂或用完
E10:胶膜架微动开关故障
E11:胶膜架下定位微动开关故障(胶膜架上升中
开关未释放)
E12:胶膜架上定位微动开关故障(胶膜架下降中
开关未释放)
E16:预延伸胶膜架拉门被打开
E32:电池故障
E50:编绳装置打开/关闭动作失败
E51:编绳装置顶部停止开关故障
E52:编绳装置底部停止开关故障
E53:编绳装置顶部开关故障
E54:编绳装置底部开关故障
EF0:...EF9,EFA触控面板错误
EFb触控面板初始化错误(启动时无法触控)
EFC触控面板校正错誤(重覆校正)
Alarms DISPLAY F= AA
The display V is used to signal the alarms displayed
RESET button or the right LED of the display F in the
models with touch screen.
E01: emergency bumper pressed
E02: failed starting (the machine does not turn)
E03: restart after shutdown or a power cut
E04: foot crushing emergency
E08: encoder block (the carriage is not moving)
E09:
E10: carriage limit switch fault (both engaged)
E11: lower carriage limit switch fault (was not released
during carriage ascent)
E12: upper carriage limit switch fault (was not released
during carriage descent)
E16: carriage door open
E32:
E50: rope opening/closing fault (both sensor engaged)
E51: rope device stop on top sensor
E52: rope device stop on bottom sensor
E53: rope top sensor fault (was not engaged during
roller ascent)
E54: rope bottom sensor fault (was not engaged during
roller descent)
EF0:...EF9,EFA touch controller error
EFb touch controller initialisation error (do not touch
the screen during start-up)
EFC touch controller calibration error (repeat calibra-
tion)
non-volatile parameters memory; if the alarm remains
after turning on the device several times, it will be nec-
essary to substitute the EEPROM memory. This fault
does allow the machine to work although the param-
eters cannot be saved.
显示屏
E04:
中间LED闪烁，如果有一个故障是参数记忆失败，
如果机器开关机几次后报警依然存在，这将是必
要更换EEPROM存储器。此故障机器依然可以工
作但参数不能保存。
To Next Page
Loading...
