打开机器内部进行任何作业，不要把工具或物品
遗放在机器内部，另外要把电池盖盖回去。
AFTER ANY WORk CARRIED OUT INSIDE
THE CENTRE COMPARTMENT OF THE
MACHINE,
MA
k
E
SURE
THA
T
NO
OB
j
ECTS
OR TOOLS HAVE BEEN LEFT INSIDE AND
PUT THE CAPS BACk ON THE BATTERY
TERMINALS.
6.2.1 每周例行保养
清洁。使用湿布沾水或酒精擦拭，完全清洁机器
表面的灰尘。可避免机器表面的摩擦造成擦伤。
关闭机器检查胶膜架升降手臂 (1) (Fig. 6.1)。假如
升降手臂动作有问题，顶出装置 (2) (Fig. 6.1)必须
更换。
6.2.2 半年例行保养
检查导向轮控制手臂 (3) (Fig. 6.1)可以完全转动。。
需要的话更换控制弹簧。
检查前后轮，胶膜架橡胶滚轮磨损状况。 如有发
现磨损部份，必须订购原厂零件更换。
6.2.1 WEEkLY MAINTENANCE
Cleaning. Using only a cotton cloth dampened with hot
water or isopropyl alcohol, thoroughly clean away all
traces of dirt from the machine work and movement
surfaces which could cause surface friction leading to
problems in sliding over these surfaces,
Turn off the machine and check the play of the roll-
holder arm (1) (Fig. 6.1).
If the arm has any play, then the jack (2) (Fig. 6.1) must
be replaced.
6.2.2 HALF-YEARLY MAINTENANCE
Check that under rest conditions the arm moves fully to
the end of travel (3) (Fig. 6.1).
If necessary, replace the control spring.
Check the state of wear of the front and rear wheels
and the rubber-coated roller of the roll-holder carriage;
if any worn parts are found they must be replaced by
ordering original spare parts from Service Assistance.
To Next Page
