7.17 Selection between local, remote or LAN control
Starting from the Main screen, press Scroll button (12) until <P. 1> is shown and then press Enter button
(13). The actually selected control mode is shown: <LOC> for local control, <rE> for remote control or
<LAn> for LAN control.
To change: press Enter button (13) and - if necessary - enter the password (see section Activating password
protection). The actually selected control mode is blinking. Use Scroll button (12) to change the control
mode. Press Enter button (13) to program the new control mode or press Escape button (14) to cancel.
Contact the Atlas Copco Customer Centre to activate remote control.
7.18 Calling up/modifying CAN address control
Calling up
Starting from the main screen, press the Scroll button (12) until <P. 2> is shown and then press Enter
button (13).
If necessary enter the password. The next screen shows that the function is ON or OFF. Press the Enter
button (13) to change this mode. Use the Scroll buttons (12) to select <On> or <OFF> and press Enter to
program.
When this function is ON, use the Scroll buttons up or down (12) to see the node ID.
If desired the user can change this ID. Press the Enter button (13): the node ID value starts blinking. Use
the Scroll buttons (12) to change the node ID. Press the Enter button (13) to program the new node ID or
press the Escape button (14) to leave this screen or to cancel this operation.
Instruction book
42 2920 7140 90
To Next Page
Loading...
