POWER FOCUS 600 EN Service
© Atlas Copco Industrial Technique AB - 9836 6534 01
11
Service
Preventing ESD problems
The components inside the tool and controller are sensitive to electrostatic discharge. To avoid future mal-
function, make sure that service and maintenance is carried out in an ESD approved work environment.
The figure below shows an example of an appropriate service work station.
Maintenance Instructions
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guidelines:
■
Replace any defective or worn parts
Replacing the clock and calendar battery
The controller clock and calendar has a battery backup solution. The disposable battery is of type 3V
Lithium CR2032.
To replace the battery, do the following:
1. Open the front access door of the controller.
2. On the front access door, unscrew the screws on the clock/calendar cover and remove the cover.
3. Remove the old battery and replace it with a new battery of the same type.
4. Re-attach the cover and screws to the front access door.
5. Close the front access door.
General Service and Maintenance Safety
The product must only be installed, operated and serviced by qualified personnel in an industrial environ-
ment.
WARNING Electrical Hazard
The equipment contains live electrical circuits.
► Always switch off and unplug the power before removing any panels or lids.
► The removal of the plug has to be such that the operator can check from any of the points to
which he has access, that the plug remains removed.
Cleaning Instruction
Equipment should be wiped off with a damp/wetted cloth.
Only use water, no cleaners containing solvents should be used.
To Next Page
Loading...
